1. Keep it clean.
Clean your unit outside and inside by the end of spring! All compressor elements should be inspected for dirt and stains. Use a mixture of water and detergent to clean the coolers and radiators to keep them immaculate and free of corrosion.
2. Check the coolants
The cooling liquids need to be in excellent condition to function properly. Check both the quality and the quantity of the coolants and act when needed.
3. Replace the air filters
Your compression system relies on clean air filters to run smoothly. Replace them before the start of the summer season to make sure the air quality remains optimal.
4. Replace the oil filters
The quality of your oil rapidly deteriorates at higher temperatures, leaving behind more residue in the oil filter. Be prepared and replace your oil filter beforehand to guarantee a flawless compression process.
5. Change the oil
While you’re at it: it’s best to change the oil before the heat arrives. Replace your oil by one that is suitable for high temperatures, such as Paroil S Xtreme and Paroil Extra. Be sure to top off correctly and avoid over- or underfilling.
6. Remove obstructions
Any obstruction in the unit may cause a restriction of airflow. So, remove any item or tool lying about inside, such as rags, books, tools, etc. – in the unit. Check for loose panel or foam as well and should you find any, be sure to put them in place again.
You are now officially ready for summer!
Need support?
We’re always ready to support you … on-site and remotely. Please contact your nearest Atlas Copco Center. Get in touch if you need service or parts, or spare parts!