Add on features / Tunnel Profiler / Tunnel Profiler
Tunnel Profiler
Atlas Copco Tunnel Profiler is a fully integrated scanning system that measures how the excavation conforms to pre-planned design.
Scanner unit.
A main objective in tunnelling and drifting is to drill and blast to an optimum contour at the lowest total cost. Any deviations from the specified profile can be costly and time consuming to correct later on. Atlas Copco Tunnel Profiler is a fully integrated scanning system. The drill rig operator will after just a few minutes of scanning see how the excavation conforms to preplanned design. By using this system under- and overbreak can be corrected at an early stage of the tunnelling cycle. The Atlas Copco Tunnel Profiler can be offered to all Atlas Copco drill rigs with Rig Control System.
Features and benefits
- Tunnel profiling as a normal operation during round drilling
- Fast profiling, only five minutes to scan a 5 meter section of 65 m2
- Result data, contour and drill log combined
- One set-up and navigation only
- Possible underbreak is advised
- Overbreak is calculated and presented
- Reduced need for surveying work
- Scanning while drilling the next round
- Navigation with the Profiler
Downloads
- Technical specification Tunnel Profiler (220.614kB, Pdf document)
