The wide operating range of an air motor makes it probable that a number of different motors could run at the same working point. Where on the torque-speed curve you find the working point affects your choice of motor.
Because it is most efficient to run the motor at the speed produced by maximum power, selecting the motor that produces maximum power as close to the working point as possible will give you the best possible alternative. This motor will also give the lowest air consumption for a given power output.
If stable speed of the air motor is important you should avoid working with speeds below the point of maximum power. This assures that there is some “reserve power” in the case of load increase. It is also a good idea to work closer to the idling speed when there is uncertainty about the torque demand.
Low speed/high torque places a high load on the gears. High speeds affect the lifetime of the vanes.
If a very long lifetime is demanded, a large motor that is restricted or run at a low pressure should be chosen.
As indicated in the photo:
High starting torque
High air consumption
High vane wear Low gear wear
Average wear of most parts
Low starting torque
Low air consumption
High load on gears
Low vane wear
Atlas Copco Tools and Assembly Systems . Ground Floor, Mantri Alpine -301 Bavdhan Bk, Maharashtra ,Pune-411021 India.
Easily handle your Atlas Copco orders and errands whenever it suits you. Note this is only for registered partners, please contact us to know more.