Fresh Air | August 2021
1. Top tip: How to select the right compressor oil
The combination of your compressed air installation, your application and the ambient conditions is unique to you. So, to get the best performance and reliability of your installation, the right choice of compressor oil is crucial.
2. The new OGP+ takes on-site oxygen generation to the next level
Think every pressure swing adsorption oxygen generator is the same? Think again. The Atlas Copco OGP+ optimises PSA technology to give you a double-digit reduction in the total cost per unit of O2 and top-quality oxygen.
3. Engineering Futures webinar on sustainability
Oliver Kent, our Product Marketing Manager, will be presenting a webinar about ‘How to make compressed air generation less expensive and more sustainable’ at the sustainability segment of the Engineering Futures series of virtual events on September 29th at 11am.
4. How to pick an inline compressor filter
You already know that filtration plays an important role in a compressed air system. But do you know how clean your air needs to be, or which filter is needed for removing which type of contaminant? Our blog helps to clear up any confusion.
.
5. AIRnet compressed air piping systems from Atlas Copco
The right piping system makes all the difference in ensuring that compressed air reaches your point of use in optimal condition, with the correct pressure and flow. Browse our catalogue to find the right pipes and fittings or get design support with our calculation tools.
6. Everything you wanted to know about spare parts
Air filters, oil filters, oil separators, line filters, lubricants – all of these components are vital to your compressor’s performance. Our series of short videos explains everything you need to know about each part, comparing genuine to non-genuine.
7. What happens if you run multiple compressors without a controller?
Without a central controller, the load/unload pressure of each compressor must be set to react to changes in air demand. Ultimately, it will lead to a higher pressure than required, hence a higher energy cost. A master controller will automate the control and optimise your system.
8. Smart productivity is coming soon
You don’t cut corners when it comes to efficiency. But sometimes the best path to superior productivity is not a straight line. Stay tuned for our exciting new product launch!