We suggest changing from Internet Explorer to another option. The Internet Explorer browser is no longer supported by Microsoft.
Please install or upgrade one of the browsers below.
Milestone for Boomer S1 D as 500th rig goes to Macedonia
Milestone for Boomer S1 D as 500th rig goes to Macedonia
December 11, 2015
It’s been called The King of Small Drifts – and there are 500 good reasons why. That’s the number of Boomer S 1D drill rigs that have been delivered until mid-2015.
Atlas Copco is celebrating the delivery of its 500th Boomer S1 D drill rig. The milestone rig was recently delivered to the Sasa Mine in Macedonia, one of Europe’s largest zinc and lead producers.
Since its launch in 2011, the success of this single-boom rig has been impressive in small and narrow drifts up to 31 m2 in cross section. Highly regarded for its productivity and efficiency, it offers a boom dampening system and a FOPS approved cabin with an interior noise level below 80 dB.
Positive feedback
"Results from the Sasa Mine show that face drilling productivity has increased by 50 percent since the Boomer S1 D was put into operation."
"It has a service friendly design which minimizes downtime. We’ve also had positive feedback on the boom dampening system which reduces uncomfortable bounce and wear during tramming."
Owned and operated by SASA Doo Makedonska Kamenica, the Sasa Mine exports 100 percent of its production and prides itself on keeping high standards for productivity and safety. It has relied on Atlas Copco for cutting edge mining equipment since 1972.
Today, a total of 23 units are at work in the mine including four of the celebrated Boomer S1 D rigs, five Scooptram ST3.5 loaders and two Diamec 232 core drilling rigs. A fifth Boomer S1 D, along with a Scooptram ST7 loader, was also commissioned in the summer, 2015.
Berggren concludes: “Sasa Mine has launched a project to increase production to one million tonnes of zinc and lead ore per year and we are confident that the Boomer S1 D will play an important role in achieving that goal.”
Epiroc operated under the trademark “Atlas Copco” prior to January 1, 2018.
When business slows down, drilling contractors may have to lay-up some of their equipment. But when things pick up again, the equipment may no longer be “fit and ready” to take on new assignments. Here’s the best way to find out.
Tomorrow’s underground mines will be more remote with orebodies that are difficult to reach and consequently more dangerous to excavate. Against this background, Atlas Copco’s Mattias Pettersson says mining companies have only one option.
Most surface miners agree that bigger blastholes reduces the cost of blasting but also increases the cost of hammers and bits. For example, mines have been switching from 152–171 mm (6–6 ¾ in) holes to 215–250 mm (8 ½–9 in) holes to increase productivity....