Working Tools

For your daily machine operation

Contact us +40 728 977 224

Working Tools

Atlas Copco offers a broad range of handheld working tools, with the highest level of quality. Shank steels are produced to ISO 1180 dimensional tolerances, ensuring correct fit between the tool bushing, tested and approved for use on the Atlas Copco breakers. You can set them to work on the toughest job sites and for the most complex applications, as they have been manufactured with the same quality standards as your Atlas Copco breakers. And as with the main breaker parts, you can find the part number clearly stamped even after use, for your reference. The working tools are manufactured from low-carbon steel, combining the benefits of a hardened case without the risk of core brittleness. With a softer core, the working tools provide optimum resistance to bending stresses that typically occur with handheld powerful breakers. This results in longer lifetime, while protecting your breaker from secondary damage (e.g., on the piston). Our wide portfolio allows you to choose the best tool for each application, increasing productivity and reducing cost of operation.

Working tool recommendation

Working tool Application
Moil point Breaking in concrete and hard material. General-purpose tool with wedge action to break off a fragment
Narrow chisel Breaking in concrete and hard material. General-purpose tool that controls the line of fracture
Wedge chisel Breaking in concrete and frozen ground. A heavy-duty tool giving a progressive wedging force
Wide chisel Cutting in medium hard to hard asphalt
Asphalt cutter Cutting hot rolled asphalt. Gives a straight and clean cutting edge
Digging spade Cutting asphalt or loosening material prior to excavation
Digging chisel Digging and loosen material prior to excavation where the ground conditions are difficult
Clay spade Cutting or digging in heavy dense clay or frozen ground. The scoped, curved profile gives efficient cutting
Tie tamper Compaction of ballast under railway sleepers
Tamping pad Consolidation of sub-base backfill and asphalt patching
Driver Driving rods and stakes, for example,  into the ground
Wedge plug and feather Rock splitting 
Bush hammer Re-dressing of concrete or natural stone
Features: Benefits:
  • Top-quality steel and optimized heat treatment
  • Increase the lifetime and reliability of both your breaker and the working tool itself
  • Shank steels are produced to ISO 1180 dimensional tolerances 
  • Total versatility: these tools can be used in the Cobra, and in pneumatic, electric and hydraulic handheld breakers from Atlas Copco.
  • Avoid the secondary damage that tools with wrong dimensions cause in the impact mechanism. 
  • Wide portfolio with the right tool for each application
  • Increase your productivity and reduce your cost of operation (time, energy, etc.)