Dinamik Kompresörlerin Regülasyonu
23 Şubat, 2022
Basınçlı havayı farklı şekillerde işleyebiliriz ve bu süreçlerde farklı araçlar kullanılmaktadır. Dinamik kompresörlerde basınçlı hava debisinin regülasyonu hakkında daha fazla bilgi alın.
Regulating Air flow
Kompresör Regülasyonu Hava kompresörleri Basınçlı Hava Wiki Sitesi Kompresör Regülasyonu ve Kontrolü
In a lot of cases, applications require constant pressure in the compressed air system. This, in turn, requires that the compressed air flow from the compressor center is regulated. There are a number of flow regulation methods available.
What types of flow rate regulation systems are there?
As mentioned above, there are a lot of flow regulation methods available, depending on the type of compressor, acceptable pressure variations, air consumption variations and acceptable energy losses. Energy consumption represents approximately 80% of the total life cycle cost for compressed air, which means that the choice of a regulation system must be made carefully. This is primarily due to significant differences in performance broadly with regard to compressor types or manufacturers.
In an ideal case scenario, the compressor's full capacity could be precisely matched to its air consumption, for example, by carefully choosing the gearbox's transmission ratio (as this is something that is frequently used in process applications.) A number of applications are self-regulating, i.e. increased pressure creates an increased flow rate, and as a result, stable systems. Examples include pneumatic conveying systems, ice prevention, chilling systems etc. However, in most applications, the flow rate must be regulated. This is usually performed using regulation equipment that is integrated in the compressor.
There are two main groups of regulation systems:
Continuous flow rate regulation involves the continuous control of the drive motor or inlet valve according to variations in pressure. The result is normally small pressure variations (0.1 to 0.5 bar), depending on the regulation system's amplification and its regulating speed.
Load/unload regulation is the most common regulation method and involves the acceptance of somewhat larger variations in pressure between two limit values. This takes place by completely stopping the flow rate at the higher pressure (off-loading) and resuming the flow rate (loading) when the pressure has dropped to the lowest limit value. Pressure variations depend on the permitted number of load/unload cycles per time unit, but normally lie within the 0.3 to 1 bar range.
Related articles
Deplasmanlı Kompresörlerin Regülasyonu
22 Nisan, 2022
Basınçlı havayı farklı şekillerde işleyebiliriz ve bu süreçlerde farklı araçlar kullanılmaktadır. Deplasmanlı kompresörlerde basınçlı hava akışının regülasyonu hakkında daha fazla bilgi alın.
Kompresör odasının gerekli olup olmadığını belirleme
31 Mayıs, 2022
Kompresör kurulumu, eskisine göre daha kolaydır. Yine de hala dikkate almanız gereken bazı şeyler vardır. Bunlardan en önemlisi kompresörün nereye konacağı ve kompresör etrafındaki odanın nasıl düzenleneceğidir. Burada daha fazla bilgi alabilirsiniz.