It is very difficult to get rid of all run-out, but it is important to minimize it as the end quality of the hole is ultimately affected. In other words – the final hole will not be 100% round if there is too much run-out.
There are many factors affecting the amount of run-out, including:
When tightening a tool chuck, use all 3 positions to tighten with an even torque, using the chuck key. This will create equal pressure from all three jaws in the chuck holding the drill bit and reduce run-out (picture 2). Check the inside of the chuck jaws for damage or wear. If the jaws are worn, this could create excessive run-out. A chuck is a consumable and should be changed from time to time, depending on usage.
It is helpful to know the statistics regarding reasons for run-out so that you can assess and anticipate why this may be happening. Most likely – 90% of the time – the drill bit in use is damaged or corrupt. 9% of the time run-out is experienced, the tool’s chuck teeth are damaged or worn out. Only 1% of the time is the actual tool damaged or not assembled correctly (picture 3).
Easily handle your Atlas Copco orders and errands whenever it suits you. Note this is only for registered partners, please contact us to know more.