Did you know?
Up to 70% of the life cycle cost of a typical air compressor installation goes into energy consumption. With the Optimizer 4.0, our newest advanced central controller, you will generate and sustain energy savings
What if I run multiple compressors without a central controller?
Without our central controllers, the load/unload pressure of each compressor can be set to react to changes in air demand. If the system pressure drops, an additional compressor will switch to loaded running. However, the sequence will always be the same, and the advantages of a Variable Speed Drive are not fully put to use. The result: higher pressures than required, too much unloaded running and … a steep energy bill.
What about load distribution of my compressors?
Our central controllers can be set to prevent unequal wear of compressors, equalizing the running hours on multiple machines for more efficient service scheduling.
Remote View Monitoring
Monitoring & controlling is no longer confined inside the compressor room. REMOTEVIEW mirrors the Optimizer 4.0 user-interface to any monitoring device through a Local Area Network (LAN).Remote control of the Optimizer 4.0 itself is also possible. You are able to change pressure/flow setpoint, integrate & isolate units and select the optimization profile that can done with sufficient access rights.
Smart View
Get rid of high cost of system monitoring integration and have your own Atlas Copco designed local visualization screen for machine parameters, compressed air & flow demand, power consumption and other notifications that can be viewed remotely via Local Area Network.
Technical specifications
Optimizer 4.0 Leaflet
- Optimizer 4.0 Leaflet 1.7 MB, PDF
