Our solutions
Βιομηχανικά εργαλεία και λύσεις συναρμολόγησης
Solutions
Service
Βιομηχανικά εργαλεία και λύσεις συναρμολόγησης
Expert Hub
Βιομηχανικά εργαλεία και λύσεις συναρμολόγησης
Products
Βιομηχανικά εργαλεία και λύσεις συναρμολόγησης
Power Equipment
Solutions
Αεροσυμπιεστες
Solutions
Προϊόντα
Αεροσυμπιεστες
Προϊόντα και λύσεις
Solutions
Αεροσυμπιεστές
Προϊόντα και λύσεις
Αεροσυμπιεστές για ναυτιλιακές εφαρμογές
Εξοπλισμός επεξεργασίας αερίων και αέρα
Δράπανα
Προϊόντα και λύσεις
Στόλος ενοικιαζόμενων μηχανημάτων
Προϊόντα και λύσεις
Accessories
Στόλος ενοικιαζόμενων μηχανημάτων
Air
Nitrogen
Στόλος ενοικιαζόμενων μηχανημάτων
Offshore equipment
Steam
Στόλος ενοικιαζόμενων μηχανημάτων
Εξυπηρετούμενες βιομηχανίες
Ελαφρύς εξοπλισμός κατασκευών και κατεδαφίσεων
Ηλεκτρογεννήτριες

What is “run-out” in handheld drills?

When referring to handheld drills or drilling units, run-out (or runout) occurs when the drill bit does not circulate around its own axle in an absolutely straight line.

It is very difficult to get rid of all run-out, but it is important to minimize it as the end quality of the hole is ultimately affected. In other words – the final hole will not be 100% round if there is too much run-out.

There are many factors affecting the amount of run-out, including:

  • The drill bit
  • The chuck or collet
  • The operator
  • The tool
handheld-drills-1-air-motors
handheld-drills-2-air-motors
handheld-drills-3-air-motors

How to ensure run-out is reduced

When tightening a tool chuck, use all 3 positions to tighten with an even torque, using the chuck key. This will create equal pressure from all three jaws in the chuck holding the drill bit and reduce run-out (picture 2). Check the inside of the chuck jaws for damage or wear. If the jaws are worn, this could create excessive run-out. A chuck is a consumable and should be changed from time to time, depending on usage.

When run-out occurs

It is helpful to know the statistics regarding reasons for run-out so that you can assess and anticipate why this may be happening. Most likely – 90% of the time – the drill bit in use is damaged or corrupt. 9% of the time run-out is experienced, the tool’s chuck teeth are damaged or worn out. Only 1% of the time is the actual tool damaged or not assembled correctly (picture 3).

Articles Air Motors Air motors