Our solutions
Atlas Copco Rental
Solutions
Atlas Copco Rental
Atlas Copco Rental
Atlas Copco Rental
Atlas Copco Rental
Atlas Copco Rental
Compressors
Solutions
Compressors
Compressors
Compressors
Compressors
Compressors
Compressors
Industrial Tools & Solutions
Solutions
Industries Served
Industrial Tools & Solutions
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Industries Served
Products
Industrial Tools & Solutions
Products
Products
Products
Products
Products
Products
Products
Service
Industrial Tools & Solutions
Service
Service
Expert Hub
Industrial Tools & Solutions
Expert Hub
Expert Hub
Expert Hub
Expert Hub
Expert Hub
Expert Hub
Expert Hub
Expert Hub
Industrial Tools & Solutions
Power Equipment
Solutions
Power Equipment
Power Equipment
Power Equipment
Power Equipment
Power Equipment
Vacuum solutions
Solutions
Vacuum solutions
Vacuum solutions

# Calculating the Working Pressure

The compressed air equipment in an installation determines the requisite working pressure. The correct working pressure does not just depend on the compressor, but also on the design of the compressed air system and its piping, valves, compressed air dryers, filters, etc. Different types of equipment can demand different pressures within the same system.

## How do we calculate the working pressure for compressed air equipment?

Normally, the highest pressure determines the requisite installation pressure and other equipment will be fitted with pressure reducing valves at the point of consumption. In more extreme cases, the method can be uneconomical and a separate compressor for special needs can be a solution. It should also be kept in mind that the pressure drop quickly increases as flow increases. If a change in consumption can be expected, it makes economic sense to adapt the installation to these conditions.

Filters and special dust filters, have a low initial pressure drop, but become clogged over time and are replaced at the recommended pressure drop. This factor will enter into the calculation. The compressor's flow regulation also causes pressure variations and therefore must also be included in the assessment.

It may be appropriate to perform calculations using the following example: It is the primarily the end consumer application along with the pressure drop between the compressor and the consumer that determines the pressure the compressor will need to produce. The working pressure can be determined by adding the pressure drop to the system, as shown in the example above.

Read more on the different aspects of dimensioning compressor installations below.

### Related articles

#### Installing a Compressor

Installing a compressor system is easier than it used to be. There are still a few things to keep in mind though, most importantly where to place the compressor and how to organise the room around the compressor. Learn more here.

#### Cost Saving Opportunities for Compressors

In many compressed air installations there are often significant and unutilized cost-saving possibilities. Learn more on how to save on compressor running costs here.