10 trin til en grøn og mere effektiv produktion

CO2-reduktion for en grønnere produktion – alt, hvad du har brug for at vide

Alt, hvad du har brug for at vide om din pneumatiske transportproces

Find ud af, hvordan du kan skabe en mere effektiv pneumatisk transportproces.
Close

# Calculating the Working Pressure

The compressed air equipment in an installation determines the requisite working pressure. The correct working pressure does not just depend on the compressor, but also on the design of the compressed air system and its piping, valves, compressed air dryers, filters, etc. Different types of equipment can demand different pressures within the same system.

## How do we calculate the working pressure for compressed air equipment?

Normally, the highest pressure determines the requisite installation pressure and other equipment will be fitted with pressure reducing valves at the point of consumption. In more extreme cases, the method can be uneconomical and a separate compressor for special needs can be a solution. It should also be kept in mind that the pressure drop quickly increases as flow increases. If a change in consumption can be expected, it makes economic sense to adapt the installation to these conditions. Filters and special dust filters, have a low initial pressure drop, but become clogged over time and are replaced at the recommended pressure drop. This factor will enter into the calculation. The compressor's flow regulation also causes pressure variations and therefore must also be included in the assessment. It may be appropriate to perform calculations using the following example: It is the primarily the end consumer application along with the pressure drop between the compressor and the consumer that determines the pressure the compressor will need to produce. The working pressure can be determined by adding the pressure drop to the system, as shown in the example above.

Read more on the different aspects of dimensioning compressor installations below.

Calculating and Measuring the Air Requirement
Calculating and Measuring the Air Requirement
Learn how to calculate the compressed air required to run your different tools.

Learn how to calculate the compressed air required to run your different tools.
Learn how to calculate the compressed air required to run your different tools.
Centralization or Decentralization?
Centralization or Decentralization?

Dimensioning at High Altitudes
Dimensioning at High Altitudes
Learn more about dimensioning a compressor installation and dealing with a higher altitude.

Learn more about dimensioning a compressor installation and dealing with a higher altitude.
Learn more about dimensioning a compressor installation and dealing with a higher altitude.

### Related articles

#### Bestemmelse af, om et kompressorrum er vigtigt

31 May, 2022

Det er nemmere at installere et kompressorsystem end tidligere. Der er dog stadig et par ting at huske på, og vigtigst af alt, hvor kompressoren skal placeres, og hvordan rummet skal organiseres omkring kompressoren. Få mere at vide her.

#### Omkostningsbesparende muligheder for kompressorer

28 June, 2022

I mange trykluftanlæg er der ofte betydelige og uudnyttede omkostningsbesparende muligheder. Få mere at vide om, hvordan du sparer på kompressorens driftsomkostninger her.

#### Trykluftfordeling

20 December, 2022

Der skal træffes en række beslutninger, når et trykluft distributionsnet skal designes og dimensioneres. Få mere at vide om det her.