They are both statistical terms that are used to evaluate inspection results.
Quality assurance jargon is sometimes obscure to those who approach it for the first time. Two of the more confusing QA-related terms are surely Cm/Cmk and SPC. Both are statistical terms that are used to evaluate inspection results.
The first term: Cm, refers to two different parameters that assess the capability of a machine. That’s what the C and the M in this term stand for Capability and Machine. In our case, the machine that we want to assess would be a tool, so we often hear that Cm and Cmk are capability indexes for a tool.
Once a series of torque readings have been collected from a tool, we can use the formulas to evaluate the Cm and Cmk for this tool. The Cm index would tell us how close the results are to one another and thus the tool’s repeatability. The Cmk index would tell us how close the results are to the target results and thus the tool’s accuracy.
These indexes are positive values and the higher the values, the better the repeatability and the accuracy of the tool. To have accurate Cm/Cmk values, usually, about 20 to 25 rundowns are needed. This is only possible if the tool is not used continuously on a production line.
Typically, Cm/Cmk tests are done before a tool is assigned to an application in the manufacturing process or after service or a repair.
How can we be sure that a tool is working correctly when it is continuously used without stopping production? This is where the SPC comes in handy.
SPC stands for Statistical Process Control. By collecting only a few torque samples and feeding them every day into the SPC formulas and plotting them onto run charts, we can easily prevent a tool from going out of spec. This is because the SPC will check from trending values or values with a non-normal statistical distribution, alerting Quality Managers, and allowing them to take actions quickly.
So, getting back to the title question, Cm/Cmk or SPC? It is now clear that the answer is both. Each at the appropriate time helps a manufacturing plant keep their tools under control.
Questions? Contact Atlas Copco to learn more or schedule a product demonstration today.
Contact us for industrial assembly tools and Atlas Copco IAS product: SCA industrial dispensing systems
Atlas Copco Tools and Assembly Systems LLC
3301 Cross Creek Parkway
Auburn Hills, MI 48326 USA
+1 (248) 373 3000
SCA industrial dispensing systems +1 (248) 377 9722
Atlas Copco Henrob
30000 South Hill Rd
New Hudson, MI 48165 USA
+1 (248) 493 3800
Emergency & Technical Support:
+1 800 4HENROB (800 443 6762)
Contact us for Fabrication and Maintenance tools
Atlas Copco Tools and Assembly Systems
4428 Underwood Rd
LaPorte, TX 77571 USA
+1 (281) 448 5900